unarchive In The Box of 11.3104 keyboard_arrow_down
- 8 - 2252 - Link Assembly Bushings
- 16 - 2251 - Link Assembly Bushings
- 8 - 15.10.167.39 - .875OD X .562ID X 1.960L Center Sleeve
- 2 - 9.11101 - 1/2 Ounce Tube of Formula 5 Prelube
add_shopping_cart Suggested Parts 1keyboard_arrow_down
Replace the front control arm bushings at the same time for the maximum benefit to your vehicle's handling.
lock Warranty Information keyboard_arrow_down
- Energy Suspension warrants its products against defects in workmanship and material for 24 months when used on passenger cars and light trucks. Products that have been abused, altered, or incorrectly installed are not covered. Energy Suspension will replace defective products or component parts, if inspection for factory personnel determines the part to be defective. Warranty replacement covers only the product. Labor claims, time loss, or freight charges will not be honored.
HyperFlex Control Arm Bushings
A control arm bushing plays a vital role in a suspension. Replace that faulty O.E. rubber bushing with an Energy Suspension Hyperflex control arm bushing. These polyurethane bushings provide the longevity and performance needed to maximize a suspension's efficiency. Energy Suspension's Hyperflex polyurethane is a firmer bushing than the O.E. Not only does this increase the longevity of the bushing but gives the suspension a boost in handling performance. With a firmer bushing, there will be a slight increase in NVH (noise, vibration, and harshness), but most drivers prefer the boost in performance in spite of that.
The Faulty O.E.
As your suspension travels, a rubber control arm bushing is repeatedly stretching and flexing. After a while, the center sleeve begins to sag and your suspension alignment is throw out of whack. The sagging will go on until the rubber fails completely.
Be sure to use Formula 5
A control arm bushing rotates a lot against the metal shell, so make sure you grease it well with Energy Suspension's own Formula 5 Bushing Lubricant. Using plenty of grease is the best way to ensure a long lasting part without any squeaking. If you'd like some extra grease just in case, pick up an extra 3 pack or an 8 ounce tube.
Product Reviews for 11.3104 | Rear Control Arm Bushing Replacement | Mazda RX7 79-85
- 5 Star (5)
-
-
- 100%
-
- 4 Star (0)
-
-
- 0%
-
- 3 Star (0)
-
-
- 0%
-
- 2 Star (0)
-
-
- 0%
-
- 1 Star (0)
-
-
- 0%
-
Energy Suspension 11.3104
starstarstarstarstar" Review 1 Year Later "
I purchased control arm bushings last year (2019) for my RX 7. I had no problem with installation nor have I experienced any issues after installation. 5 stars for your product.
verified_user Verified Buyer - Roger E Gardner - . Energy Suspension 11.3104 - 5 out of 5starstarstarstarstar" Review 1 Year Later "
I purchased control arm bushings last year (2019) for my RX 7. I had no problem with installation nor have I experienced any issues after installation. 5 stars for your product.
verified_user Verified Buyer - Roger E Gardner - . Energy Suspension 11.3104 - 5 out of 5starstarstarstarstar" Great Value "
Did their job! I had what I think was called wheel hop.. the rear end seem to bounce or wiggle when driving. Research online suggested these parts and after ordering the wrong parts from Autozone Online I found this suspension.com and they sent the Right Parts that did the trick!
verified_user Verified Buyer - Orlando Braxton - . Energy Suspension 11.3104 - 5 out of 5starstarstarstarstar" A good value "
The rear arms on the old RX-7s are a bear to get out. These urethane replacements are a tight fit and correct size. The car handles about the same as the rock hard 30 year old rubber and vs. spending $400 on the OEM arms with the rubber bushings a good alternative. All in all v. satisfied...
verified_user Verified Buyer - Steven Smith - . Energy Suspension 11.3104 - 5 out of 5