Front End Alignment Kit - Ford Bronco II - moog-k8736

  • moog-k8736 Front Caster Camber Bushing

Front Caster Camber Bushing

Manufacturer: MOOG
Part Number: moog-k8736
Price: $77.74

check_box In Stock check_box Ships Immediately


  • Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.

    WARRANTY:

    Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.

    Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.

    If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.

    Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)

FitmentFront Caster Camber Bushing moog-k8736 fits these vehicles:

Front End Alignment Kit - Ford Bronco II - moog-k8736

Moog Alignment Parts

Caster or Camber issues? Moog has got you covered with their line of alignment parts. Moog's engineers have designed this part to give you adjustability and flexibility with the alignment angles in your suspension. Whether caster, camber, or both, Moog's alignment parts will set your suspension up better than when you first drove the vehicle off the lot.

Box4

question_answer Customer Questions and Answers


Question:
I have a 1985 bronco ii, just installed a 4 inch lift kit. it has a bad case of positive caster. would this part help me align it back?
Answer:
k8736 will adjust camber and caster */- 2 3/4 degrees. If you are wanting to adjust the caster only you would need K8746. This goes on the radius arm. I have used these and they work really well.