11.5115 | Rear Sway Bar Bushings - 11mm | Mazda Miata MX5 06-14

Crafted using Energy Suspension's Hyperflex Polyurethane, these Front Control Arm Bushings can withstand almost any impact, lasting much longer than those old gates... I mean bushings.

Brandon Fly- DST Parts Guru

Energy Suspension 11.5115

Poor Handling and Excessive Leaning?

The handling on your Mazda Miata NC isn't as good as it could be, am I right? You just can't cut those corners like you want to without feeling like you're about to flip over. In addition, you may have also started to hear clunking sounds coming from the rear end. These issues could be caused by failed OE sway bar bushings. These bushings are designed to grip your sway bar and hold it firmly to the frame, allowing your car to keep all four wheels on the ground while taking a fast corner. Your OE bushings are made of a soft rubber that stretches itself out over time. Eventually, these bushings crack and rot away, leaving you with a loose sway bar and severely reducing your ability to corner. Not only that but after going over a bump your loose sway bar could bang into other chassis parts, potentially causing even more damage.

Increase Your Sway Bar's Performance!

This is Energy suspension's 11.5115, an 11mm set of HyperFlex polyurethane rear sway bar bushings designed specifically for your 2006 - 2014 Mazda Miata NC. These Hyperflex polyurethane bushings are designed to last much longer than the OE rubber and are not prone to the same stretching, cracking, and rotting. The 11.5115 not only stays in shape longer but once they are installed the 11.5115 will make your sway bar perform like an even larger bar! We here at DST make sure to let everyone know it's crucial to measure your sway bar before you buy bushings for it, that way you can be sure you get the correct size. For more information on measuring your sway bar, check out our How-To Video on our universal sway bar bushings page!

Carve All The Corners You Want!

Energy Suspension also made the 11.5115 easy to install! Each bushing has a split on the flat side, allowing you to just slip the bushing on instead of having to slide it all the way into place. This innovative design also lets you keep the sway bar on your Miata during the install, saving you time and effort, and don't worry, once you tighten down the brackets this gap will disappear. Which leads me to another important note, the 11.5115 was made to fit your OE bracket and bolts, saving you money and effort by removing the chance of you having to find and purchase hardware.